Ensure that the engine cannot be started. The Caterpillar Monitoring System is enabled after the engine is started. For engines that are rated at 1301 rpm and above, see Illustration 31. When it is necessary to remove a component at an angle, only use a link bracket that is properly rated for the weight. Use of gloves is recommended.
Use a 139-2789 Ferrule Crimp Tool to crimp a wire end 7 to the end of each wire. We prefer happy customers for their purchases and loyalty to, and we hope to receive recommendations to other potential customers. This manual very useful in the treatment and repair. Read and understand the basic precautions listed in the safety section before operating or performing lubrication, maintenance and repair on this product. Compensation — Compensation is used to adjust the time delay between the control signal and the movement of the actuator.
Attach the wire end that is the appropriate gauge onto the end of the wire. Motor has an automatic reset thermal protector. The inlet manifold pressure is used to indicate the engine load. Illustration 16 g01242443 Location for the customers connection inside the remote panel 3. This line compensates for changes in boost pressure or in air filter restriction. The alarms and shutoffs are set at critical operating temperatures, pressures, or speeds in order to protect the engine from damage. Cut one wire and connect the wire to the appropriate location on the terminal strip.
The power supply can supply 20 amp of continuous power. The warnings in this publication and on the product are, therefore, not all inclusive. None of the indicators are illuminated. Always wear protective glasses for servicing batteries. The default settings that are programmed at the factory are listed in Table 9.
Ensure that the filler cap is cool before removing the filler cap. Adjust the fuel supply pressure to the fuel valve between 1 and 5 Psig. Specs Bore - mm in 170. Maintenance Intervals Perform maintenance on items at multiples of the original requirement. Intermittent Duty D Ratings - For vessels operating at rated load and rated speed up to 16% of the time up to 50% load factor. The maintenance schedule items are organized for a preventive maintenance management program. Batteries must be kept clean.
The maximum allowable rating of the fuse is 60 amp. If a sign is attached to a part of the engine that is replaced, install a new sign on the replacement part. Retain the information for future reference. All Manuals Are Windows and Mac compatible! When this output is activated, the output is connected to ground. Table 9 Overspeed Parameter Default Setting 1. Determine the normal operating range by observing the gauges over a period of time. The second is the great quality that you will find in this manual.
Use the following guidelines when any replacement parts that contain asbestos or debris that contains asbestos are handled. Illustration 10 Illustration 10 describes a typical connection inside the interface box. Table 7 Temperature correction factor look-up. Remove the filler cap slowly in order to relieve pressure. Diesel Parts Direct is not an authorized dealer for Caterpillar, Cummins, or Detroit Diesel. The valid configurations of the inputs are described in Table 5. Uncontrolled electrical circuit paths can also cause electrical activity that may degrade the engine electronics and communications.
The maximum water pressure for cleaning purposes must be below 275 kPa 40 psi. The maximum allowable rating of the fuse is 20 amp. Engine efficiency and engine performance depend on adherence to proper operation and maintenance recommendations. Failure to follow the warnings and instructions could result in injury or death. It covers every single detail on your Caterpillar 3516 Marine Engine. Inspect the threaded plug and the O-ring. Set the engine speed control.