. Equipment, models and prices may vary by dealer. Remove chute from mower deck or blower assembly. Make sure belt guide F is indexed properly into hole G on tension arm H. Any such part repaired or replaced under the warranty is warranted for the remaining warranty period. Dealers may sell for less. Excessive Fuel Consumption Choke is not fully open.
Third party trademarks referenced herein are trademarks of those third parties. The right is reserved to make changes at any time without notice. When you see a broken line ------ , the item referred to is hidden from view. Entanglement in a belt or sheave can cause serious injury. Install electric clutch wiring harness back through frame hole and connect to main wiring harness. Clean thoroughly around reservoir fill cap before opening. Entanglement in a belt or sheave can cause serious injury.
The engine horsepower and torque information are provided by the engine manufacturer to be used for comparison purposes only. This manual and safety signs on your machine may also be available in other languages see your authorized dealer to order. Year of Manufacture: 2011 Pros: control , size , fuel econmy, The mower is great! Also the 534 was much safer on ditches. It looks like cornrows after each pass! Turn key switch to the start position. Turn left blade C as shown. Installing Mower 48 and 54 Inch Mowers 1. Component is spring-assisted and under tension.
Check oil level on dipstick. Do not get off machine. Hold drive belt and turn right blade D as shown. Unless otherwise indicated, taxes, freight, setup and delivery not included. The rear wheels are powered by strong and resilient Parker wheel motors. Check area below machine for leaks. Offers valid in the United States.
Move the machine to an outside area before running the engine. Move the motion control levers forward to begin forward travel. Stored energy can cause blades to rotate. Product features subject to change. Row after row of unmulched grass forms along the side of the strip I just cut.
No matter what John Deere zero-turn mower you choose, you can rest assured you are getting a machine designed to meet your needs. Travel speed is too fast for conditions. Replace worn or broken parts. Briggs and Stratton Model Number. To turn slightly to the left, push right control lever C further forward than the left control lever D.
Year of Manufacture: 2008 Pros: I have owed my Z445 since 2008 and it has approximatley 450 hours on it at the present time. Be sure mower is fully raised to the transport lock position, as shown, and insert the pin A in the hole just below the mower deck lift lever B. Remove pin A , lower mower deck, and install pin just above lever B to lock mower in lowered position. Information given in this manual will provide the operator with the safest and most effective use of the machine. I have not had one problem with the machine as of yet. Taxes, freight, setup, and delivery not included.
Inspect the foam precleaner E without removing it. Disconnect the negative battery cable or remove the spark plug wire for gasoline engines before servicing the machine. Do not use hands or feet to clear plugged mower deck or blower assembly. Cons: The muffler is to close to the ground. Children or bystanders may attempt to move or operate an unattended machine. Component is spring-assisted and under tension. If I get off the mower to pick up a stick in the yard there will be a brown spot in the yard the next day where I stoped at.
Attachments: None Modifications: None I will cut to the chase and sum it up like this: If your done playing around and wasting your time with lawn tractors then it is time to buy a John Deere Zero Turn mower. Refer to the John Deere Z425 manual for servicing the engine, transmission, checking and replacing any belts, making any adjustments, replacements parts and numbers, plus the John Deere Z425 manual offers troubleshooting tips, such as if machine moves with engine running and hydrostaticcontrol in neutral. Drain plug spills oil all over the frame. Allow engine and muffler to cool completely. Move machine only by hand. Wait for all moving parts to stop before getting off to inspect machine.