Never hold it in your hand or across your legs. Always clean the battery pack using only a dry cloth. Keep proper footing and balance at all times. Do not use the Cordless Drill if it has been damaged, left outdoors in the rain, snow , wet or damp environments, or immersed in liquid. If unreadable or missing, contact Alltrade for a replacement. If not, your tool mayexperience a loss of power, excessive voltage drop or overheating.
Many accidents are caused by poorly m aintained tools. Keep cutting tools sharp and clean. No further lubrication is required. The drill might be brand engineered from a generic manufacturer and so a battery from the same drill under a different brand might fit and be available. Before disposing of dam- aged or worn out Ni-Cad batter y packs, check with your State Environmental Protection Agency to find out about special restrictions on the disposal of these batter y packs, take them to your local recycling center for proper disposal, or call 1-800-822-8837. Do not grasp the tool or place your hands too close to the spinning chuck or drill bit. Their part number is 2103992 and list price is 23.
Make sure the bit is actually cutting and not spinning in the hole as this will dull the edges of the bit. Accessories that may be suitable for one tool may create a risk of injur y when used on another tool. The battery pack can explode. Maint Summary of the content on the page No. Good luck, please let me know how this works for you! Always check the direction of the Cordless Drills rotation before use. The theory here is that over time, oxides built little bridges in a ni cad battery between the anode and cathode thus shorting the battery, shocking the battery burns those bridges and if the cells are still intact it will work again. Try shop force or Master craft.
If the blade is not at full speed, the saw may kick backcausing serious personal injury. Always remove the battery pack before attemptingcleaning or maintenance. Store tool and battery pack in locations where temperatures will not exceed120°F. This is the safety alert symbol. If not, your tool may experi- ence a loss of power , excessive voltage drop or overheating.
So when something goes bad you have to replace the entire drill only comes in the combo pk. Press the batter y pack into place. Make sure the bits are sharp. Too little and Always clean the battery pack using only a dry cloth. W W A A R R N N I I N N G G indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
Keep the handle of the Cordless Reciprocating Saw dry, clean, and free from oiland grease. When the battery pack requires recharging, a 3-5 hour charge allows the tool tooperate at full power. However I would strongly recommend that you look at the battery online to make sure it will match up. Keep your work area clean and well lit. Such preventive safety measures reduce the risk of starting the 5 6 tool accidentally.
Never over -discharge a batter y by using the tool even after tool performance has decreased. Keep the handle of the Worklight dry, clean, and free from oil and grease. Subsequent recharging needs 3-5hours for the battery to be fully charged. Never use the cord to carr y the tool. The battery pack and charger heat during charging.
A battery that gets too hot can have a shortened life. Remove the battery pack from theWorklight. Holding the work by hand or against your body is unstable and may lead to loss of control. The various types of cell are available from Amazon and ebay as well as specialist suppliers some with solder tags that don't need welding and youtube has plenty of helpful how to videos. Batterypack terminals could be short circuited causing damage to the battery pack,severe burns or fire.
Do not use the Cordless Drill if the batter y pack is not seated properly. Use a dust mask or respirator for applications which generate dust. Always check the direction of the Cordless Drill's rotation before use. Do not carry battery packs in aprons, pockets, or toolboxes, product kit boxes, drawers, etc. Always unplug the charger before cleaning it.
Severe heat is most destructive to a battery; the more heat generated, the faster the battery loses power. A charging indicator light on the charger will illuminate to show that charging is taking place. The first times will spark and then as the bridges burn the spark will decrease. Keep your hair , clothing, and gloves away from moving parts. Hold the rear end of the chuckin one hand and use the otherhand to rotate the front end ina counterclockwise direction toopen the jaws of the chuck. The correct tool will do the job better and safer at the rate for which it is designed. Always keep theventilation openings clear.