To remove the toner and other particles that are accumulated at the edge of the cleaning blade, the drum turns in reverse for about 5 mm at the end of every copy job, as shown in the illustration. In general, user manual contains written guidelines and related images. Then, remove the front cover. If the paper size actuator is broken, or if there is no tray installed, the Add Paper indicator will light. Turns on the exposure lamp. I was happy to receive manual in true electronic form, instead of scanned original. If more than 10 copy jams occur, the oldest data will be erased.
A stronger filter gives sharper lines. Adjusts the scanning start position on the white plate for auto shading. Auto Energy Saver mode: Off 1 August 1996 Auto Shut Off mode: On - All configurations System Auto Reset Timer 0 ~ 180 s Auto Shut Off Timer 5 ~ 120 min. Do not touch the charge roller with bare hands. As a result, the feeler rotates upwards. If the temperature of the thermofuse reaches 169°C, the thermofuse opens, removing power from the fusing lamp.
Close any other applications, as they may be interfering with printing. Unpack the copy tray and remove the tape. Displays the total number of copies by magnified Japanese version only. Do not change the value. Do not change the value. What happens in energy saver modes 1 and 2 The behaviour of the machine in energy saver levels 1 and 2 is the same as in the copier only configuration fusing lamp at low temperature. This informs the cpu what paper size is loaded in the tray and that the tray is in place.
Auto Energy Saver mode: On Auto Shut Off mode: On - Copier Configuration System Auto Reset Timer 0 ~ 180 s Auto Shut Off Timer 5 ~ 120 min. The meaning of the display is as follows. Never use alcohol to clean the drum; alcohol dissolves the drum surface. Control Panel Gain access to all system capabilities in seconds. Be careful to avoid touching those components with your bare hands.
. The specification is 2 ±1. When printing a document, specify the paper size and paper type and select the paper tray in the printer driver so that the settings configured when paper is loaded can be used for printing. Secure the inverter unit with the screw which was removed in step 4. Do not adjust this value. Take care not to scratch the drum as the drum layer is thin and is easily damaged. Products are shown with optional features.
In this mode, the fusing lamp turns off and the machine will not print anything coming in from a computer. Increase if the paper is getting wrapped around the drum. Vertical Line - 1 dot 5. Erase Margin The specification is 2 ±2 mm. A greater number of lines gives a more detailed copy.